Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to open the switch of macro definition in ise4.x/5.x?

Status
Not open for further replies.
F

fighter

Junior Member level 1
Joined
Dec 6, 2002
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
52
ise4.x/5.x

hi,anybody knows how to open the switch of macro defination in ise4.x/5.x
series software,i use xst to synthesis the verilog code,because my codes have
some ifdef...else ...endif,but ise seems like not to support this kind of defination?is it right?any solutions？thanks!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top