Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How do you draw a Wedge (i.e. solid triangle) in HFSS

Status
Not open for further replies.
N

newbie101

Member level 2
Joined
Apr 25, 2005
Messages
47
Helped
7
Reputation
14
Reaction score
3
Trophy points
1,288
Activity points
1,751
Hi All,

I'm trying to draw a wedge in Ansoft HFSS.
Since there isnt any command for that.
I drew a box and a two planes cutting through the box.
Now Im trying to use the "subtract" command to remove two slices of the box,
so i get a solid triangle wedge. However it doesnt work.

Can anyone please suggest a correct way to do this.

regards,
newbie
 

Can you put a sketch of the wedge you are tyring to draw?

Added after 1 hours 27 minutes:

Did you try drawing a triangle with 'Draw line' command? Just draw the 3 sides of the triangle. It should form a surface.
 

you could also try uniting 4 triangles and a square (or a rectangle).
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top