Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

K179 for stepper motor driver

Status
Not open for further replies.
H

hassan1980

Full Member level 4
Joined
Jan 14, 2005
Messages
204
Helped
9
Reputation
18
Reaction score
6
Trophy points
1,298
Activity points
1,340
k179 unipolar stepper

Did anyone build k179 for stepper motor driver.

I built this project depending on the schematic diagram but it didn't work.

Would you please give me details?

The link of this diagram is : https://www.kitsrus.com/gif/pdf.gif

I am waiting your replies.
 

To troubleshoot this circuit you may need an oscilloscope ..

Start with checking supply voltages: +5V for circuit and whatever is required for motor supply ..
Then check if the oscillator based on IC2-B oscillates .. and folow that signal through D-latches to the outputs of MOSFETS ..

Regards,
IanP

RTW the correct link to K179 kit is: https://kitsrus.com/pdf/k179.pdf
 

IanP said:
To troubleshoot this circuit you may need an oscilloscope ..

Start with checking supply voltages: +5V for circuit and whatever is required for motor supply ..
Then check if the oscillator based on IC2-B oscillates .. and folow that signal through D-latches to the outputs of MOSFETS ..

Regards,
IanP

RTW the correct link to K179 kit is: https://kitsrus.com/pdf/k179.pdf
Click to expand...

Hi, again

I built this circuit but I want a more stable stepper motor drive circuit.

on the other hand, I want an explanation of the difference between {bipolar stepper} and {unipolar stepper motor}.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top