Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Where to start designing matching networks?

Status
Not open for further replies.
B

BD

Member level 1
Joined
Oct 14, 2004
Messages
38
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
321
Matching Networks.

Hi,
does anyone out there know anything about Matching Networks.
I want to Design matching networks to operate at a frequency of 750MHz, and a bandwidth of 10MHz to match a load of 75W to a source of 50W.

where should i start.
 

Re: Matching Networks.

Yes,
It is matching a 75ohm load to a 50ohm source.
 

Matching Networks.

You have several techniques to do so like:
1- Lumped elements.
2- Single stub.
3- Double stup.
4- Tappers.

Check the books above.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top