Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

8 Layered PCB for PCB designers

Status
Not open for further replies.

taring77

Full Member level 2
Joined
May 20, 2004
Messages
144
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Activity points
1,330
www.pcbsoftwear.com

Hi all,
i have a 8 layered PCB to Convert from one software to another. there is about 15% of changes to the cct .
May i know what is the possible time line for this 8 layered PCB.
Major Components are :
289BGA (MCU) , 100pin TQFP (controller chip), 2x54pins TSSOP (RAM), 56 pin TSSOP (FLASH). Plus connectors n smallers cct.
Sch is about 8 pages in total.

Also all major part for schematic is to be created. The schematic also need to be converted.

So from anyone experience how long will it take?
PS: do include how long experience u have in this line..

thanks
 

Dear;

To convert PCB from tool to another
A- U can Convertion tool if it avilable.
B- Reroute the Bourd agin as flow:
1 - out the gerber file from the PCB
2 - create Packeg for U'r Component in new Software.
3 - convert the grber o DXF or any other format that U can input it as imege in the new PCB Softwear
4 - Convert Schmatic.
5 - load the net list and then route the new board exact as imege that U extract it from old PCB and inpuit it in new softwear.

it can tack about 2 week depend on tool and the PCB Engeneer that will work. I hoop that my help is in it's position as U want.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top