Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For a regulator you must search dynamic characteristics there are several test. One of them is to test the response to load change. If your regulator gives 1 AMp maximum, you must have two charges one of 10% of 1 AMp, and the other 90% of the 1 AMp.
You must start from 10% full charge and then change to 90% of full charge, and after a time the inverse. You must check the output voltage with a osciloscope and verify the oscilation (natural frequency) and how much tim takes to decrease to zero. The other factor is how much the signal goes high (it refears to dumping factor).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.