Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Print Spice simulation in Orcad

Status
Not open for further replies.

doofus32

Junior Member level 2
Joined
Jan 13, 2006
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,448
When I try to print the Spice simulation done in Orcad the lines get wery thin, is it possibly to get it thicker?
 

You have to right-click on the actual line of the waveform, then you can choose thickness and also color. Just take your mouse right over the actual thin line of the waveform and try it out.

Best regards,
v_c
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top