antp
Junior Member level 2
I have a similar problem, as in
The question is:
how correctly to define port on single-layered PCB for dipole antyenna model in free space without ground plane using ansoft designer
It seems to me, the input impedance of antenna 0.257 x 50 = 12.85 Ohm on resonant frequency 6.8 Ghz is too small
Look at attachment
antp
The question is:
how correctly to define port on single-layered PCB for dipole antyenna model in free space without ground plane using ansoft designer
It seems to me, the input impedance of antenna 0.257 x 50 = 12.85 Ohm on resonant frequency 6.8 Ghz is too small
Look at attachment
antp