Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to define the op-amp parameter in this low-pass filter?

Status
Not open for further replies.
C

cqmyg5

Advanced Member level 4
Joined
Oct 21, 2003
Messages
118
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,298
Activity points
963
Hi,

I want to design a op-amp on 0.18u CMOS process, which could be suitable for this low-pass filter.

For simulating the op-amp, I have to define the load cap and load resistor, what's the value? it's 2.653pF and 70.71k/100k as showed in the figure? OR, it's not neseccery to care about these cap/res
 

please give me a hand, thanks!
 

Re: How to define the op-amp parameter in this low-pass filt

Your opamp needs to drive 100kohm resistive load and 2.6pF capacitive load, with certain amount of gain-bandwidth-product. This GBW should be 5~10 time higher than your LPF corner frequency.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top