Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to design a less sensitive filter to etching tolerances?

Status
Not open for further replies.
R

rf100

Member level 1
Joined
Mar 13, 2004
Messages
37
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,288
Activity points
264
Coupled line filter

Hi
I designed an microstrip edge coupled line filter at 5 GHz ,the bandwidth is 300 MHz,with 5 section on RT/duroid 5880, I used filter wizard in Microwave office and then tuned the dimention(lengths, widths and spacing )
it seems that my filter is sensitive for small variation in the dimientions of the filter
my qustion is how to design the filter to be less sensitive to the etching tolerances
Thanks
 

Re: Coupled line filter

You have four options.

1. Make the bandwidth wider so that your desired frequency range is within the passband at the limits of etching errors.

2. Use a lower dielectric constant material. This will increase the dimensions and the etching errors will be a smaller fraction of the dimensions.

3. Try some other filter topology that might be less sensitive to the dimensions. I cannot think of any, but other board members may know of them.

4. Use a more expensive fabrication method that has lower etching tolerances or use thinner metal (which will decrease the chemical etching time and undercutting) and then plate the thickness up.
 

Re: Coupled line filter

You have one fore important Option apart from flatulent mentioned

complete the design by allowing production tolerances on
the track and the board material, and analyse using the Yield analysis...

Then finally get the Component Sensitivity Histogram plots..
use the Yield optimizer (Design center the parameter) to make less sensitive...
Sensitivity analysis is obtained by adding a Ysens measurement to a graph.

For an example go through the AWR installation folder...
AWR\AWR2004\Examples\Circuit Features\Yield Analysis\Ku_Band_ECM.emp
 

Re: Coupled line filter

Sometimes you can increase the gap spacings by screwing around with the filters in/out impedance. Use a λ/4 transformer before the filter, and another one after the filter.
 

Re: Coupled line filter

Thank you all for your ideas,
another thing, when I measured the filter the lower passband has more insertion loss than the higher passband,eventhough the return loss still good "below -15dB"
is that normal for this kind of filters,
 

Re: Coupled line filter

Attached is an example on Coupled Line Filter Synthesis and Analysis using AWR Microwave Office...
WHich shows a typical example on Simulated vs Measured response...
I think your results looks OK!...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top