kashimonga
Junior Member level 1
Hi all,
I use Layout Plus 10.3.0. in some cases we need to have a track that has a wide width (e.g. 60 mils for VCC or GND). but we may have components that have low pad spacing such as SMD ICs. if we want to route these tracks to these components, we may route the track with wide width (60 mils) to a point near the component pin and then change the width property to a fewer value (10 mils) and continue routing to the component pad with this ne width.
Is it possible to tell to Layout Plus to do this width change automatically in autoroute proccess?
I know that SPECCTRA (Allegro) does this.
I use Layout Plus 10.3.0. in some cases we need to have a track that has a wide width (e.g. 60 mils for VCC or GND). but we may have components that have low pad spacing such as SMD ICs. if we want to route these tracks to these components, we may route the track with wide width (60 mils) to a point near the component pin and then change the width property to a fewer value (10 mils) and continue routing to the component pad with this ne width.
Is it possible to tell to Layout Plus to do this width change automatically in autoroute proccess?
I know that SPECCTRA (Allegro) does this.