Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

regarding phase noise analysis

Status
Not open for further replies.

us1710

Junior Member level 3
Joined
Aug 3, 2005
Messages
27
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,519
Hi , I have designed an oscillator with 2.4G oscillation frequency. I am new to the phase noise simulation in SPectre. I followed the pss and pnoise set to simulate phase noise, it gives me error when running pss, complaining something like "arithmetic exception error". Can i know why?? I have tried by changing tstab value, but still has this error.

Please advise. Thanks.
 

i know how to do phase noise analysis for oscilator in Cadence tools. if u want i can send u related stuff.
 

can u plz send me the stuff which describes troubleshooting in PSS analysis, because i was stuck in that only , it may be convergence problem. do u know how to solve it? hv u faced this type of "arritmetic exception" problem.
 

I think you have asked this question in another topic before. Hope this will help. "Before you run the PSS, maybe you would like to run a transient analysis to check how long does it take for your oscillator to start oscillating. From this, you can key in the tstab. If the same problem occured, maybe you should change the tolerance options under simulator options to a finer resolution. This may help in your convergence issue."
 

Hi,

if you can simulate your oscillator with a Harmonic Balance based simulator
you should have no longer accuracy problem.

All simulators with HB method propose phase noise analysis,
like EldoRF or Ads.

Bozzo.
 

u can try by using differential circuit structure in the oscillator.

search this one,

L. Dai, DESIGN OF HIGH-PERFORMANCE CMOS VOLTAGE-CONTROLLED
OSCILLATORS, Kluwer Academic Publishers, 2003
 

I seen most of u guys are facing problem in performing PSS and phase noise analysis.here i uploaded a file .how to perform PSS and phase noise anylsis using cadence tools. please follow those steps.
Best Of Luck
 
  • Like
Reactions: jjv

    jjv

    Points: 2
    Helpful Answer Positive Rating
Sorry guys,

a simple question for expert people.. I see you r worried to have an efficient analysis of your oscillator.. Then I suppose you are going to compare the results of your analysis with your specification requirements..

The question is: what are the major system considerations leading to the determination of the specification mask for the phase noise of your oscillator? What's the phisical meaning of a requested envelope?

I'm quite new on this topic (my interest is on planar antennas) and I request your support.

Hope you find this consideration interesting and you can share with yours with me in a fruitful discussion.

Regards

Lupin
 

I have the same question. who can explain it ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top