Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with Pad and Via holes in POWERPCB printouts

Status
Not open for further replies.
C

crypted

Junior Member level 3
Joined
Dec 27, 2002
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
126
Hello everybody.
I have used POWERPCB 5.0.1 and been new on it.
I see everything on the PCB board but i don't see via and pad holes
in PCB printouts. Namely all holes are filled. What should i do to see empty holes in pads and vias?
Thanks a lot for helps
 

Usually one wants solid areas for vias and pads. Therefore the standard via configuration has a padstack with round pads. I guess that if you change that to annular, and give an inner diameter >0 you should see the "hole"
 

press "f4"key!!!!!
 

hello again.
@ted
thanks for help but my all pads and vias are annular type. i see the drill holes during the design time but they are all filled in PCB PRINTOUTS
 

Add in the padstak one anular shape.

Only game pcbcad print the oles in pads.

Bye
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top