Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I know it should be a contact. But is it a cell name or a layer name? If it is a cell name, then it is possible that metal/active connection and metal/poly connection use different cells.
Only use contact to connect poly and metal 1, and also the area of contact should meet the e-spec, and current flow density. connect different metal layer with via. Normally a good pdk will have a tech lib for the via, contact, ptab and ntab etc.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.