Antonio_Magma
Full Member level 2
What is the correct process of development from a Simulink model to a C6713DSK?
1. Build model using normal Simulink blockset and Signal Processing blockset
2. Generate C code using Real-Time Workshop for Code Composer Studio and Embedded Target for C6000
3. Compile code in CCS
is this correct?
Because i always though that the so called Embedded Target for C6000 itself contains signal processing blocksets specifically for TI C6xxx DSPs and if i want to generate C code for TI DSPs i should build using blocks in Embedded Target for C6000.
Please verify. Thanks guys.
1. Build model using normal Simulink blockset and Signal Processing blockset
2. Generate C code using Real-Time Workshop for Code Composer Studio and Embedded Target for C6000
3. Compile code in CCS
is this correct?
Because i always though that the so called Embedded Target for C6000 itself contains signal processing blocksets specifically for TI C6xxx DSPs and if i want to generate C code for TI DSPs i should build using blocks in Embedded Target for C6000.
Please verify. Thanks guys.