---
+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Newbie level 3
    Points: 1,338, Level: 8

    Join Date
    Aug 2005
    Posts
    4
    Helped
    0 / 0
    Points
    1,338
    Level
    8

    non-manifold edges hfss

    Hi. I am new to HFSS and am encountering the following problem.

    I am modeling two cascaded cavities and am getting the following error. 'Non-manifold edges found for ...'.

    I have narrowed the problem to the point that I have removed all the walls except for a vertical plate attaching at the center of a a horizontal plate. I am still getting the problem.

    I think that HFSS is confusing whether the attached edge is inner or outer. However, I don't know how to solve this problem.

    I will really appreciate your comments.

    •   Alt15th August 2005, 00:10

      advertising

        
       

  2. #2
    Newbie level 4
    Points: 1,818, Level: 9

    Join Date
    Jun 2003
    Posts
    6
    Helped
    2 / 2
    Points
    1,818
    Level
    9

    non-manifold edges

    I have had similar problems
    This kind of problem occurs when two objects "touch" each other.refer figure (a)
    The remedy is to make objects large enough that they overlap as shown in figure (b).
    After that unite or intersect the objects as shown in figure (c).
    I hope this will solve your problem
    and your program will run happily.:D
    tell me how to make a free mirror.


    2 members found this post helpful.

    •   Alt22nd September 2005, 15:14

      advertising

        
       

  3. #3
    Junior Member level 3
    Points: 1,621, Level: 9

    Join Date
    Jun 2004
    Posts
    24
    Helped
    2 / 2
    Points
    1,621
    Level
    9

    non manifold edges

    good ,I got the problem too



+ Post New Thread
Please login