dsbirch
Newbie level 2
at+mipcall
Hi everyone,
I've read a similar thread here but had no answers, so I'll post my problem here. I'm trying to establish a GPRS session using a Motorola G20, and onto UK's O2 Pay-as-you-go GPRS service. My problem is once I try to log into the access point with the AT+MIPCALL command, it returns +MIPCALL: 0 with no further message and gives me no IP address. Roughly, the sequence of commands I'm using is the following, and the SIM card doesn't have the PIN number enabled:
I'm using the developer's kit, with the silly phone thing included, and on the phone screen I can read "GPRS session" once I activate the PDP context (AT+CGACT=1 command). I've successfully downloaded data with the same card using my own telephone, and (I believe) the same APN settings, so I'm sure GPRS is enabled and working with that card and network.
Any ideas?
Thanks everyone for your attention.
Hi everyone,
I've read a similar thread here but had no answers, so I'll post my problem here. I'm trying to establish a GPRS session using a Motorola G20, and onto UK's O2 Pay-as-you-go GPRS service. My problem is once I try to log into the access point with the AT+MIPCALL command, it returns +MIPCALL: 0 with no further message and gives me no IP address. Roughly, the sequence of commands I'm using is the following, and the SIM card doesn't have the PIN number enabled:
Code:
AT+CGDCONT=1,"IP","payandgo.o2.co.uk"
OK
AT+CGATT=1
OK
AT+CGACT=1
OK
AT+MIPCALL=1,"payandgo.o2.co.uk","payandgo",""
+MIPCALL: 0
I'm using the developer's kit, with the silly phone thing included, and on the phone screen I can read "GPRS session" once I activate the PDP context (AT+CGACT=1 command). I've successfully downloaded data with the same card using my own telephone, and (I believe) the same APN settings, so I'm sure GPRS is enabled and working with that card and network.
Any ideas?
Thanks everyone for your attention.