Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Question on Differential Folded Cascode OTA Simulation

Status
Not open for further replies.

Pack

Newbie level 1
Joined
Aug 4, 2005
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,290
Qn on OTA Simulation

Hi,
I had designed a Fully DIfferential Folded Cascode OTA. Now I want to characterize this OTA for CMRR,PSRR,SFDR,IMD,Slew Rate etc. The measurement setup for some of the above parameters need OTA to be configured in Unity Feedback. Now the question is

1. Can I have equal valued RESISTORS in input and feedback side of OTA which has 1pF load at both outputs?

2. If reistors are not allowed for OTA and should capacitive feedback alone be used to construct unity feedback for OTA, Please tell me the way of setting the DC bias for this.

3. For CMRR and PSRR measurements, is it needed to introduce mismatch in differential pair?

4. Can anyone tell me the way to simulate SFDR for an OTA.

Thanks Forum,
Pack
 

Re: Qn on OTA Simulation

If you use resistor make a unit feedback, just be aware the open loop gain will be affected by the resistor if its value is not large enough

use capacitance, be aware it will affect bandwidth and phase for it adds load to the output

for the smrr and psrr, do not introduce the mismatch to the differential pair. check their definition
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top