Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need knowhow to reduce SAR(specific absorption ratio)

Status
Not open for further replies.
U

uummcc

Member level 2
Joined
Jan 26, 2002
Messages
50
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
202
reduce sar

SAR is a measurement of near field strength.
Somebody say SAR is proportional to antenna gain and pattern.
But antenna gain is from far field measurement.
Therefore, I think SAR can be reduced even using a larger gain antenna.
But I don't know how.
I need some suggestion from you.
 

reduce sar+antenna

Some FCC Test reports on FHSS digital phone has been posted in USA FCC Website, you can search the SAR (Specific Absorption Rate) report if you know the model (FCC ID). Panasonic phone will do test requirement.

**broken link removed**
 

does flip phones reduce sar

SAR is a dosimetric parameter; then it is a measure of the amount of the e.m. energy effectively absorbed in a body exposed related to the mass of the same body. This parameter is affected by several factors, not only by the source characteristic, i.e. antenna pattern, power, frequency and so on. It is related also to the dieletric characteristics of the part of the body exposed, dimension, distance from the source, other reflecting bodies, and so on ..

Regards
 

specific absorption ratio antenna

I suggest U can try to use patch antenn design.
 

My experience is that this is a very difficult subject. It is hard to measure and even harder to corrrect. In many cases, SAR radiation from the PCB far exceeded that from the antenna so many fixes we had to do were with the circuit board.
For cell phones, the clamshell design, such as the Moto V60/70 tilts the antenna away from the head and puts the flip between the antenna and the head and this helps a lot with antenna related SAR.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top