Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Is there any TIP designing analog CMOS using BSIM3v3?

Status
Not open for further replies.

020170

Full Member level 4
Joined
Jan 31, 2005
Messages
231
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,298
Activity points
2,221
Hi everyone.

someone who used to design "Analog" IC,for example, Opamp, using BSIM3 know a truth that every mosfet in the circuit has been "saturated". if not, the circuit is not work properly.

Bsim3v3 is very accurate Mosfet model. Bsim3v3 have 132 ( is it right? ) parameters and saturation current equation is very complex .

So it is very difficult to meet every condition by using hand calculation method.

next picture is an example.

**broken link removed**

I have to saturate 4 mosfet. it is easy. but I want to not only saturate mosfets,
and also I want to adjust accurate Vds each mosfet.

To determine desirable Vds, it is not easy, sometimes it is impossible work.

is there any way to adjust Vds?

if you have any idea better than me, plz tell me.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top