Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Many years ago before electrically erasable PROMs there were fused ones. The fuses were usually polysilicon. The PROM was programmed by blowing the fuses. There was a reliability problem as you could imagine with the material from the blown fuses being spread all over the IC surface.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
