Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
u have to add a pin in the schematic and then u can add a pin in the already created synbol.if u dont want to do this,then delete the previous symbol and then create a new symbol with the pin added to the schematic.
yibinhsieh gave you the best answere. you have to be carefull when you update the symbol because adding pins by hand on a previously created symbol can cause problems when you export schematics in cdl format and then use this format for verifications. be very carefull especially with busses because the pins inside one bus are added in chronological order so is you expand a bus you could get in cdl two busses with the same name instead of one. this is oooooooooonly an example of what can happend if you don update a symbol in the corect way.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.