Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Calibre LVS Extraction Report Warnings Question.

Status
Not open for further replies.

Trafford

Newbie level 4
Joined
Nov 15, 2019
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
34
Hi, Everyone. Attached is my Calibre LVS report. There is no error shown in my LVS report, but some warnings show up in LVS extraction report. Could these warnings affect the final results? Thanks!
 

Attachments

  • lvs.png
    lvs.png
    22.4 KB · Views: 246

Could these warnings affect the final results?
No, I wouldn't think so.

The warnings just inform that the power PATHCHK couldn't be performed because of unattached power labels and ports. So the electrical - not the physical! - connectivity between MINUS/GROUND and PLUS/POWER respectively - and of Vbias - had not been checked.

You should perhaps highlight the concerned nets in the extracted layout and make sure that they are connected correctly.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top