Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ADS:Error while adding bat54 component in ads layout from HFDiode library

Status
Not open for further replies.

pratiks15

Newbie level 2
Joined
May 7, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
15
whenever I try to add BAT54 SOT23 diode in ads layout it shows a dialogue which says: The cell " " does not have the same units and database resolution as the current design. What should I do?
 

Change the Units in Technology Library..If it's mils, change it as mm etc.
 
Thank you this worked!

However now when I try to make any connections I get this error.

I have attached a screenshot of the error warning message.JPG
 

Thank you this worked!
However now when I try to make any connections I get this error.
I have attached a screenshot of the errorView attachment 152938
The message is clear.. The layer which is used for landing of that component is not valid.Change the layer with a valid one, error will be disappeared.
Or define this layer in tech. file..
 

.. or if that layer is required by a component library, add that layer to your workspace library in the layer settings.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top