Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

which component i need use in proteus for code "sensor"

Status
Not open for further replies.

jerryxiang

Newbie level 2
Joined
Mar 26, 2017
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
15
I used microcontroller 18f4550 for my circuit but which component for the "Dsensor" use in proteus professional isis7?

 

You can use a push button to simulate the door sensor, use the one you have not wired up. You will need a pull up resistor, you can either use a external 10K pull up resistor or enable the internal pull up on Port B. Wiring the processor reset to port RB5 is not what the question meant, wiring the processor reset to RB5 serves no function, you should have a separate reset button.
The reset circuit for the MCLR pin should not be used in a real circuit, a simple 10K pull up resistor is sufficient.
 
Last edited:

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top