Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help me about load cell amplifier

Status
Not open for further replies.
I

ikramjadoon

Newbie level 3
Joined
May 29, 2006
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,298
Please configure the resister value for opa2277 load cell amplifier circuit. Load cell 200 kg input supply 10 v output 3mv / v.
Thanks
 

hi,
Are you considering building a Bridge INA amp, using two OPA2277.?
If so, the resistors must be close tolerance values.
The Gain formula is shown in this clip from the d/s.

E
 

Attachments

  • A002.gif
    A002.gif
    18.3 KB · Views: 108
Last edited:

Thanks for reply .but I m confused for (v1 and v2) . What means for that.

In the formula v out= (v1-v2)(1+R2/R1). So v1 and v2 what means. Please explain.
Thanks
 

Hi,

V1, V2, R1, R2 all is clearely described in the schematic.

****
In post#1 you ask for resistor values, so you should show a circuit, too.

Post#2 is more clearely than post#.

Klaus
 

From v1 means 3mv or 30 mv ???
And from v2 zero .??
???
 

hi,
Assume a L/C excitation voltage of 10Vdc and L/C bridge sensitivity of 3mV/V
Also the mass being weighed is 200kG.

The L/C bridge would give an output of 3mV * 10Vext = 30mV at FSD of 200kG on the two Signal V1 ,V2 wires from the bridge.

Say you required an amplified voltage output of 5V, the amp would require a Gain of Vout/30mV = 166.67'

Choose R2 as 20k, this means that R1 would have to be in the order of 120R.

Plugging these values into the Vout = (V1-V2) * ( 1+ (R2/R1)) .

Vout = 0.03 * (1 + (20,000/120)) = +5.03V

E

EDIT:
This LTSpice sim shows your project.
It is IMPORTANT that the resistors are close tolerance, ideally 0.01%
 

Attachments

  • A003.gif
    A003.gif
    27.3 KB · Views: 104
Last edited:
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top