Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Timing Corners for setup check

Status
Not open for further replies.
I

identical

Member level 1
Joined
Feb 10, 2015
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
225
What corner is used for setup check?
Process - Slow
Temp - high
Voltage - high
This PVT condition makes cell delays as large as possible. Is this used for setup check to make setup check more critical.
 

identical said:
What corner is used for setup check?
Process - Slow
Temp - high
Voltage - high
This PVT condition makes cell delays as large as possible. Is this used for setup check to make setup check more critical.
Click to expand...

First and foremost, read the documentation that comes with the PDK. There are some nuances that are hard to capture with broad statements like "process = slow". There is also temperature inversion corners that are not intuitive.

Generally speaking, your worst setup corner is process slow, temperature high, voltage low.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top