Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Power/Ground pin is floating! Cadence-Encounter Error Message

Status
Not open for further replies.
I

inputoutput

Member level 1
Joined
Mar 18, 2017
Messages
32
Helped
2
Reputation
4
Reaction score
2
Trophy points
8
Activity points
231
During post-route timing optimization in Encounter, I get the error message, "Power/Ground pin is floating!". What does this error message mean? Verify -> Geometry reports no violations. I also ran the following command, "globalNetConnect VDD -pin VDD -inst * -type pgpin -all -override" (and same for GND) before special route of the power rings. Thanks for your help.
 

make sure the VDD pin of the std cells is actually called VDD. make sure sroute clompleted. if you have IOs, make sure you have connected them correctly.
 

The pins are VDD and GND. I searched the LEF file for "USE POWER/GROUND". However, there seems to be other VDD/GND pins as well with other names. Can I use just any VDD/GND pin?
 

inputoutput said:
The pins are VDD and GND. I searched the LEF file for "USE POWER/GROUND". However, there seems to be other VDD/GND pins as well with other names. Can I use just any VDD/GND pin?
Click to expand...

course not. go figure out why there are other power pins. could be something silly like a well, or could be the source of all your issues.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top