Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Plot the phase noise of LC-VCO in ADS

Status
Not open for further replies.

hanen88

Member level 1
Joined
Sep 29, 2014
Messages
39
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,630
Hi;
I designed a LC-VCO in ADS and i should plot its phase noise. I persued a clear Tutorial so i used HB simulation. I will send the ADS file of output voltage and the parameter which i used in HB simulation to undestand more the matter. After doing all of these steps, i can't plot the phase noise spectrum. What can i do and how can i solve this matter. I ask if the matter in the offset frequency or in another parameter in HB simulation.
noise-1.jpg
 

I have designed an LC-VCO at frequency 12.8 GHZ and i would like to plot the phase noise. I used a tutorial to do this. However, when i run simulation i can’t plot the phase noise spectrum, as it is clear that the curve it is usually zero. I would like to know the matter that evoid to plot the curve.
 

Hi;
I designed a LC-VCO in ADS and i should plot its phase noise. I persued a clear Tutorial so i used HB simulation. I will send the ADS file of output voltage and the parameter which i used in HB simulation to undestand more the matter. After doing all of these steps, i can't plot the phase noise spectrum. What can i do and how can i solve this matter. I ask if the matter in the offset frequency or in another parameter in HB simulation.

Your Phase Noise set-up is not correct.You should define PN in HB Noise Controller only and Nonlinear Noise is not your case.
HB_Controller.PNGPN_Controller.PNG
 
I disable this case of"Non linear noise", but the curve still equal as zero. What can i do please?

I'm very gratefull if you send me the tutorial which is related to my goal i need just to plot the phase noise of this LC VCO.

so, how can i adjust the "Noise analysis in HB controler" and "HB Noise Controller" to have the spectrum of the phase noise.
 

You set two noise analyses
(1) Noise analysis in HB controler
(2) Noise Controler

You can find another phase noise data in data set.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top