Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to do routing using Tcl scripts?

Status
Not open for further replies.

msdarvishi

Full Member level 4
Joined
Jul 30, 2013
Messages
230
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Activity points
2,349
Dear all,

I am using Vivado 2016.1 and I would like to do the routing between two logic resources located in different slices and CLBs. I know that this routing must pass through different switch matrixes and logic resources and I know it is possible to do it via constraints definition. I have read UG894 and UG895 but they are so extensive and complicated ! Can anybody provide me a simple example of routing between two flip-flops to extend it for my own purpose?

P.S. : Previously this task was feasible in ISE FPGA Editor by Manual routing and I know it is possible in Vivado using scripts.

Kind replies are in advance appreciated.

Thanks,
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top