Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST best mesh ?

Status
Not open for further replies.
O

Orange_1888

Newbie level 3
Joined
Nov 24, 2016
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
21
Hi everybody I 'm new to CST and would appreciate some help. My problem is very simple. I am trying to model wire antennas. I have therefore chosen the Antenna [Wire] model template.
and i want to knwo is there a typical or minimum number of cells of mesh ?

Any help/advice will be appreciated.
 
Last edited by a moderator:

Obviously accuracy of simulation is directly dependent of mesh but as you mentioned that you are new so in the beginning I would suggest that you can live with the mesh generated by CST.
The best way is to generate one mesh get results and then see how accurate they are and then go for more refinement if needed since you are using CST template so right now there is no need to be worried about mesh
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top