Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

hCoosing the thickness of copper coating when not mentioned inside an IEEE article

Status
Not open for further replies.
A

Alex329

Junior Member level 3
Joined
Oct 14, 2016
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
272
choosing thickness of copper coating when not mentionned inside ieee article

Hi

I would like to know which thickness I should apply when they don't mention it inside an article. I want to design an antenna of some ieee article . They said that the substrate top side is a copper coating also acts as the ground plane for the open microstrip line (feed) which is etched on the opposite side of the substrate but hey didn't mention the thickness of the copper coating. I am wondering how much should I take for that thickness?

thank you
 

Re: choosing thickness of copper coating when not mentionned inside ieee article

Copper plating thickness usually doesn't matter much for RF PCB, because the skin depth isn't larger than a few µm. Plating roughness is much more important.
 

Re: choosing thickness of copper coating when not mentionned inside ieee article

Calculate the skin depth - Make the copper thickness atleast 4 times the skin depth.

35um (1 Oz) copper thickness should be a good starting point.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top