Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How do I automatically get recognization the state enumeration name in simvision?

Status
Not open for further replies.
C

coshy

Member level 4
Joined
Mar 28, 2016
Messages
71
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,288
Activity points
1,778
How do I get automatically recognization the state enumeration name in simvision?

Hi.

How do I get automatically recognization map the in simvision?

As I knowm SimVision has the ability to map mnemonics to values in the waveform window to make it easier to visualize the states of the FSM.
we need to run the plug-in with ncsim to generate the mnemonics maps. However, those maps can then be used in subsequent post-processing runs of SimVision.
So I want to know how to generate the mnemonics maps automatically not at the post-processing.
 
Last edited:

Re: How do I get automatically recognization the state enumeration name in simvision

generate them once, by hand. save a simulation setup. load that setup next time you want the same mnemonics. that's how I did it 5 years ago, should still be similar
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top