PeterEE
Newbie
Hello,
I am asking advice on the following issue:
I need some sort of level translation for the following situation:
Please see attached drawing:
IC_A is providing a low level of 0.8 V but IC_B needs a low level of < 0.6 V.
The high level is not an issue. The signal clocks at 100 kHz but can be lowered if required.
What would be a simple/smart way to achieve this?
Thank you very much for any advice!
Peter
I am asking advice on the following issue:
I need some sort of level translation for the following situation:
Please see attached drawing:
IC_A is providing a low level of 0.8 V but IC_B needs a low level of < 0.6 V.
The high level is not an issue. The signal clocks at 100 kHz but can be lowered if required.
What would be a simple/smart way to achieve this?
Thank you very much for any advice!
Peter