Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Select HEMT or LDMOS for 10W PA?

Status
Not open for further replies.

tony_lth

Advanced Member level 5
Joined
Jul 28, 2010
Messages
2,086
Helped
377
Reputation
756
Reaction score
368
Trophy points
1,363
Location
Beijing
Activity points
12,621
HI,ALL,
I want to design a 10W power amp of a base station at 900M.
I found a HEMT PA and a LDMOS PA, and I am curious about at which PA I should select.
1st of all, mass production is the 1st priority.
Could you give some comments?
Thanks.

- - - Updated - - -

Sorry, the signal is GSM.
 

Attachments

  • MMRF1015N.pdf
    738.1 KB · Views: 52
  • EGNC60MK.pdf
    389.4 KB · Views: 69

So, what's the difference between HEMT PA and LDMOS PA?
 

Usually HEMT have hight ft and better power capacity. GaN HEMT owns very high power disspation ability to achieve very high power.
 
Hi, Yalisenda,
Thank you very much.
Cheers,
Tony Liu
 

the LDMOS will probably be cheaper. the LDMOS has a very low output impedance, and large output shunt capacitance, which will limit the bandwidth it can be matched over. The GaN fet has a higher output impedance to begin with, and less shunt capacitance since the devices are physically smaller, so you can do higher frequency and bigger bandwidths.
 
Personally speaking, I think LDMOS size is smaller than GaN. Since GaN is usually used in high voltage and high current.
 
If you're doing something standard like a 900MHz basestation, then you should be able to find reference designs from device manufacturers. I would look at those first, then compare the costs of each design, including supervisory circuitry (especially for HEMTs with negative gate bias). Don't worry so much about the underlying technology unless you're doing something novel.
 
Hi, mtwieg,
Thanks.
Cheers,
Tony Liu
 

HEMT transistors are more linear compare to LDMOS, take this into account.They are also more reliable at higher temperatures.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top