Rocketman46
Member level 3
Hi All,
What is the preferred easiest way to drop 3.3v usart pins to 1.8v to interface to an external device. I cannot change the Micro Vin voltage, so I will have to lower the voltage level external.
Is it acceptable to use two resistors and create a potential divider, or would you recommend another method. I have already built the board and this was an over site.
Thanks,
What is the preferred easiest way to drop 3.3v usart pins to 1.8v to interface to an external device. I cannot change the Micro Vin voltage, so I will have to lower the voltage level external.
Is it acceptable to use two resistors and create a potential divider, or would you recommend another method. I have already built the board and this was an over site.
Thanks,