Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

TRL calibration board drawing

Status
Not open for further replies.
M

Marzuliani

Newbie level 1
Joined
Aug 22, 2016
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
7
Hi All,

I want to draw the TRL board for calibration purpose. Since my RF trace including the footprint of the DUT, do I include the footprint in the drawing? or i just take into account the RF length to DUT reference (as in pic1).

Thank you

pic1.JPG
 

Usually the packaged S parameters taken by the chip/transistor manufacturers includes the pins length, so you don't need to take in consideration traces inside the DUT reference.
If you do your own S parameter measurements, better is to include traces inside DUT reference.
 
You'd better read the datasheet of your IC, most of the time the vendors set the ref plane at the edge of the package, not including the pin length. Including or not should be clearly note in the datasheet.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top