sonar_abhi
Member level 1
Dear All,
I am thinking of making a AM/FM radio using TEA5710. I was looking for a TEA5767 breakout board but was unable to locate one and found TEA5710 DIP IC instead.
I have no prior experience in designing a radio and have never done so. Can anyone please explain me the values and components mentioned in the datasheet?
1. What should be values of L1, L2, L3, etc? Can I find them as ready components or have to build them?
2. The pin 14 is a selection pin for AM/FM. According to the datasheet when it is grounded, the IC is tuned for FM reception but I do not get if it needs to be connected to Vcc for AM reception or what?
3. I want to digital tune the radio, so what should I use instead of the tuning capacitor?
May be some of the doubts are elementary and may seem obvious but one has to start learning somewhere.
Thanks,
Abhishek
I am thinking of making a AM/FM radio using TEA5710. I was looking for a TEA5767 breakout board but was unable to locate one and found TEA5710 DIP IC instead.
I have no prior experience in designing a radio and have never done so. Can anyone please explain me the values and components mentioned in the datasheet?
1. What should be values of L1, L2, L3, etc? Can I find them as ready components or have to build them?
2. The pin 14 is a selection pin for AM/FM. According to the datasheet when it is grounded, the IC is tuned for FM reception but I do not get if it needs to be connected to Vcc for AM reception or what?
3. I want to digital tune the radio, so what should I use instead of the tuning capacitor?
May be some of the doubts are elementary and may seem obvious but one has to start learning somewhere.
Thanks,
Abhishek