Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

FPGA: Migrating from ARM to microblaze

Status
Not open for further replies.

beginner_EDA

Full Member level 4
Joined
Aug 14, 2013
Messages
191
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
3,854
Hi,
I am using kintex kc705 FPGA board and VIVADO for following project:
https://www.xilinx.com/support/documentation/application_notes/xapp1199-smpte2022-56-over-ip.pdf
and it uses microblaze processor for software part.

There is another project which is built over above project by adding additional compression(JPEG 2000) feature to it.
https://www.xilinx.com/support/documentation/application_notes/xapp1244-video-over-ip.pdf
But in this project OmniTek OZ745 FPGA board (Zynq-7000) is used (not kintex kc705) along with ARM processor instead of microblaze.

I would like to know if I do below project with my kintex kc705 FPGA board and microblaze(instead of OmniTek OZ745 FPGA board / Zynq-7000 and ARM) :
1. Is it feasible from technical point of view?
2. What else is needed apart from PIN configuarion?
3. Is it feasible to migrate software part from ARM to microblaze?
4. Any other helpful tips?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top