Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] What is the best approch to connect between each other fpga board?

Status
Not open for further replies.
U

u24c02

Advanced Member level 1
Joined
May 8, 2012
Messages
404
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,101
Hi,

I'd like to connect to 3 fpga board but those fpga boards are moved away about 3 meter.

In this case, I'd like to know which the connection methodologies are better approch.

1 zynq board
2 atrix boards
Star connection between them.
 
Last edited:

Another poorly posed question using nearly incomprehensible English, that lacks any requirements, typical u24c02 question :roll:

rs422 would work great based on the information provided.

-------------------
Edit I see you've improved your question.
 

Thanks but they have each resister map and need to 40MB/s over.
Is there any good communication protocol between each other?
 

Is it 40 Mbit/s or 40 MByte/s ?

With 40 Mbit/s you can use LVDS and the old UART protocol. You may have to design the UART yourself, but it is easy.

With 40 Mbyte/s = 320 Mbit/s you will have some trouble unless your FPGAs have high-speed serial transceivers or Gigabit ethernet.
 
  • Like
Reactions: u24c02

    U

    u24c02

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top