Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello ,please what diffrernce between collector current(DC) =-100 & peak collector current =-200 in limiting values table in data sheet attached .
is the first one dc and the second is ac or what ??
The graphs of its DC current gain shows that it works very well to 10mA and poorly above 60mA. I would use it to 50mA. A BC327 has the same case but a max continuous current of 800mA. I would use a BC327 to 300mA. Beware that if it is linear with voltage across it and a high current then it will overheat.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.