Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Perhaps it is meant as the maximum frequency with the specified load the motor will *not* miss a step. It may run (it will certainly) faster but it will miss some steps. Basically they run-stop-run (it may not stop fully but it can if needed) and the rotor inertia is the problem.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.