shelkerahul
Member level 4
why is hold check done for the same edge
Hi all,
Why do we need to check the hold violations on one cycle before the setup.
eg. If I am checking the setup on 2nd cycle then I need to check the hold on 1st cycle, why it is so.
somebody help me, I am bit confuse in this.
Thanks in advance
Hi all,
Why do we need to check the hold violations on one cycle before the setup.
eg. If I am checking the setup on 2nd cycle then I need to check the hold on 1st cycle, why it is so.
somebody help me, I am bit confuse in this.
Thanks in advance