Moonwalker
Member level 2
I am driving a Triac using the MOC3083. The triac is switching a Contactor 230Vac. When switching ON is ok but when switching Off the Contactor stays energized.
If the Opto is removed the Triac switches OFF so the problem seems leakage on the Opto triac.
If the MOC3083 is replaced by MOC3063 this works fine.
On datasheets I did not find any differences between the two optos other than the working voltage.
Any help?
If the Opto is removed the Triac switches OFF so the problem seems leakage on the Opto triac.
If the MOC3083 is replaced by MOC3063 this works fine.
On datasheets I did not find any differences between the two optos other than the working voltage.
Any help?