Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

QUCS Studio - any convient way to convert SPICE 2g6 models?

Status
Not open for further replies.
T

Terminator3

Advanced Member level 3
Joined
Feb 25, 2012
Messages
802
Helped
71
Reputation
142
Reaction score
63
Trophy points
1,308
Activity points
9,027
Current version of QUCS can convert CIR files. Is there any convenient way of converting *.NET spice models in 2G6 format? There are too many syntactical errors.
 

Found another problem, my project uses functions deg2rad, angle, dB(S[2,1]) in Qucs
In QucsStudio deg2rad and angle gives "undefined/unknown function" error, while dB(S[2,1]) seems give incorrect results.
 

I remember that I ported 2g6 to run on Atari ST and IBM XT computers, but I don't know what *.NET model format is.
 

Infineon FETs,BJTs libraries for Advanced design studio simulator have many of them. Parameters for BFP405 in QucsStudio libraries are the same as Infineon's *.NET. *.CIR converter fails to convert it, but i think i can figure it out, because parameters are the same, i can compare QUCS BFP405 to Infineon's net i think
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top