Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Kf value in flicker noise calculation

Status
Not open for further replies.
P

phanikiran

Junior Member level 2
Joined
Feb 4, 2016
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
170
I want to calculate a simple CS amplifier flicker noise. The parameters for flicker noise calculation are Cox, W , L , freq and Kf. Other flicker noise constant Kf , i had remaining values. What is the value fot Kf ?
 

You have to find it in process documentation.
There are two (in fact three) basic models - Hoodge, McWorther and third is a mix of them. For modern technologies a number of "different" low frequency noise are also important and modeling them are a bit more complicated (but possible and done - You can check number of papers from solid state electronics or electron device society journals).
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top