captainssbn
Newbie level 1
Hi all
I'm using codevision with studio 7. I have a new pcb design that is connected to my pc port via a Olimex AVR ISP MK2 device. I checked the cables and all looks good. The code is from avr448 3 phase HV motor controller
The problem is when I build all program files with codevision and program the chip I get back an error
the mismatch chip signature bytes 0, 1, & 2 are 0 and should be 1E, 92, & 05 for my AtMega48 device.
If you need pics of screens I can post them.
Thanks Gary
I'm using codevision with studio 7. I have a new pcb design that is connected to my pc port via a Olimex AVR ISP MK2 device. I checked the cables and all looks good. The code is from avr448 3 phase HV motor controller
The problem is when I build all program files with codevision and program the chip I get back an error
the mismatch chip signature bytes 0, 1, & 2 are 0 and should be 1E, 92, & 05 for my AtMega48 device.
If you need pics of screens I can post them.
Thanks Gary
Last edited by a moderator: