Aks_srf
Newbie level 3
Hi,
I am using ATM90E26 on a custom board and able to communicate with it using Uart with baud 9600.
For the calibration purpose, i am following atmel application note mention here:
http://www.atmel.com/Images/Atmel-46102-SE-M90E26-ApplicationNote.pdf
After calibration, I am getting frequency of 51Hz and phase angle 350 only. All the energy registers are having zero values. I am using shunt and N Line metering method.
Can anyone please suggest me the calibration procedure for the same?
I am using ATM90E26 on a custom board and able to communicate with it using Uart with baud 9600.
For the calibration purpose, i am following atmel application note mention here:
http://www.atmel.com/Images/Atmel-46102-SE-M90E26-ApplicationNote.pdf
After calibration, I am getting frequency of 51Hz and phase angle 350 only. All the energy registers are having zero values. I am using shunt and N Line metering method.
Can anyone please suggest me the calibration procedure for the same?