Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Water level alarm

Status
Not open for further replies.

mohsen 2012

Member level 4
Joined
Jul 3, 2012
Messages
70
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,796
Hello , i build this car alarm circuit :

Screenshot 2015-08-12 19.34.10.png

WP_20160203_005~1.jpg


and i want a simple modification in this circuit to use it for a water level alarm .
please help me and thanks
 

Question: Your schematic does not show a sensor. Could it be a capacitive sensor, perhaps implied as a track on the pcb? Or do you hook up an external sensor to the circuit?
 

yes i want to add external sensor to out of the circuit
 

I think the circuit works by monitoring the 12V car battery, when some one opens a door the interior light comes on and takes current and the battery volts fall.
Q1&2 are a bistable, normally ON, when a door is opened the battery volts fall faster then the volts at Q1 emitter, so both transistors go OFF and allow the astable to squeak (Q3&4).
So connecting a 1K to Q1 base would be one probe, the other is the -12V (earth), the squeak would happen when the probes are shorted.
Frank
 

I think the circuit works by monitoring the 12V car battery, when some one opens a door the interior light comes on and takes current and the battery volts fall.
Q1&2 are a bistable, normally ON, when a door is opened the battery volts fall faster then the volts at Q1 emitter, so both transistors go OFF and allow the astable to squeak (Q3&4).
So connecting a 1K to Q1 base would be one probe, the other is the -12V (earth), the squeak would happen when the probes are shorted.
Frank
Thanks for explain , but i want to use this siren for indicate the water level , I have taken this modification, but did not give a good result :

water.JPG

when i put the 2 probes in the water , the siren sound level is very low !!!
 

Put the 2 probes in series to the base of Q4. Because the current there is low the resistance of the water will not reduce the sound level.
 

You got it right mohsen.
 

I suggest connecting the base of Q4 to ground through a 2M or higher resistor.

I once made a water detector, which also made use of a darlington pair (because the multiplied gain was needed). I expected it to draw miniscule current from the 9V battery. However instead of working for months, the battery was depleted in a couple of days.

I believe the bare wires picked up ambient 60 cycle hum, and it biased the transistors on. (After I got an oscilloscope I was able to see this occur in devices.) Current flow was not strong enough to make the buzzer sound, but it drained juice from the battery.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top