Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Create a component from a schematic in ADS

Status
Not open for further replies.

Parish

Newbie level 3
Joined
Dec 31, 2015
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
26
Hi all

I have design a direct conversion transmitter in ADS and now I wanna use it one component(the designed circuit). I tried to make symbol for designed schematic but it creates a a component with 3ports. I need a component with only 1 port to connect it to another component later. How should I do it in ADS ?

Thank you,
Parish
 

ADS will create a symbol view with ports how many there are..
If you don't want to use them all, keep them unconnected on the top level schematic. Or, delete the ports which you don't desire to see in sub-schematic.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top